can anyone tell me about what it would cost out the door to have 3x3's put on a baja with irs ( parts and labor) i just want a little more for travel and stability and the same question for the front with a kng pin front to go longer and wider? any help would be great.

These guys can help
Eagle Performance

thanks for the info what about some kind of 4 or 6 point roll cage

I just remeasured mine 2day in the rear! I got 16 1/2 with 3x3`s and stock spring plate that have been notched! Could have got more but don`t wanna risk a cv issue!

Custom fabrication shops.

Where are you located? I might know somebody who could help you with that.

im in montclair ca. not far from pomona or ontario. and maybe if your close enought we can get together have a beverage or two and you can point out stuff that needs to be done to be safe and fun.

Man, you are just down the street from Jones Fabrication. Shawn mainly does aluminum work, but he does take some projects like this occasionally. His shop is on Loma place, just off of Arrow Route(between Central and Benson). Stop by and see him to see what he can do for you.

thanks i have seen this place before i will check it out soon . ill post as i go thanks the everyone for the help.