Been wanting to re-wire my car for a long time now and finally got around to it. After working on it
off and on for the past two weeks it's all done front to back. Every circuit has its own fuse. For safety, there are
two high-amp main fuses, one feeding the front fuse block and the other feeding the engine fuse block and starter.

Overall view of the finished product under the hood:
Click to view attachment


Close up of main switch, 2 main fuses and power wires:
Click to view attachment


Close up of under hood fuse block and gages:
Click to view attachment


This is what the under hood wiring looked like before:
Click to view attachment

looks awesome nice job

Sweet..

Sano.........
Wiring is a TON of work when done right but so worth it in the long run. No more electrical gremlins with a job done like that. Nice work.

Looks great!! Please tell, where did you get the fuse block?

Thanks for the compliments everyone and ya it's a huge time sink but well worth it for the peace of mind in the end.

Waytekwire.com

Looks very nice, good job !

Here are a couple more photos of the motor/tranny area and the new engine fuse block.

Click to view attachment


New engine fuse block with a cover this time:
Click to view attachment



Original wiring in trans/motor area
Click to view attachment

Looks great. very nice job.

Damn Roger, nice work. That looks like it took a long time...

Next trip - 10/12-14 - want to check it out in person.

Sweet work

I think there are a few zip ties that are not evenly spaced- better go and re do them!



Just fooling!

Wiring looks GREAT!
Thanks for the tip to Waytekwire.com

I wonder how many PM's he will get now with "what would you charge me......? look's really good dude!!!!!!!!!!

like everyone said, looks very good man. nice work.

Extremely Clean! Nice work!

Thanks for the compliments my friend. Ya I've got alot of hours invested, especially since I made all new
mounting plates, gage brackets, rear fuse holder bracket, etc. Not to mention all the running around getting parts.
Overall it was a super fun project. I love to wire!

I'm planning on going out that same weekend. Maybe we'll finally get to dune with you this time.

Here are a couple of photos from underneath the engine cover. The engine harness was well layed out and pretty clean to begin with. I added dual fuel pump relays, ran 10G wires to the fuel pump, replaced a couple of metri-pack connectors and added a 4Gage wire to the alternator.

Click to view attachment


The original wiring under the engine cover
Click to view attachment

Looks Great!!

That would actually be a good thing. My business has been very slow lately and I could always use the extra money to get out to the dunes.
Diesel fuel and race gas aren't cheap these days.

Thanks to everyone that has replied and for the compliments.

Roger

clean and mean!

Damn..... You Do Very Nice Work!

very nice!

Did you swear a lot while doing it???

Very Very nice!!!

haha... How did you know? Sounds like you've done some wiring projects too.

Nice job , Roger is the man when it comes to wiring. He has done more than a couple of jobs for me. I had him trick out the wiring on my Rhino, dual batteries , hids, interior lights, backup lights , battery selector you name it he did it. Also this summer he rewired the back half of my Sand Cars Unlimited. Super clean work!!!

Your Hired! Nice ..Clean Job

Super Sano Job. Very nice workk....lot better than the "rat Nest'