Well I am wondering what type of grease everone is using on there Cv jonts? I'm using a mix of Bellray & Elite is there something better out there and why?

It's pretty much what I use too. An antiseize lube and moly mixture has worked best for me.

Frank

I've heard a lot of people use Cat Gold (if that's the right name).

That's the right name.

You'll get a lot of answers...

LE (Lubrication Engineers)
Cat Gold
Moly mixed with antiseze
and few others.

I personally use Lucas Red N Tacky #2.

I started off using a 50/50 mix of Belray and the other grease that most people recommend. I didn't like the way it separated and left thick sludge in the cage and liquid in the boot.

So I researched and switched to Chevron Delo Extreme Pressure II grease, designed for much higher working pressures and temps. It's about $3/tube, very tacky and stays in the cage.

Out of curiosity, I tried Cat Desert Gold. It's formulated similar to Chevron Delo EP II but a little thinner and more expensive (8-$10/tube.)

Then Lubrication Engineers was recommended to me, it's even slightly stickier than Chevron Delo EP II and sells for about $14 -15/tube.

Out of the bunch, I think the LE gives the best protection, followed closely by the Chevron, then Cat Desert Gold, then far behind those comes the Belray/moly combo stuff.

Thanks guys,
I thing I'm going to give the Cheveron a run.

I'm a huge fan of Cat Gold.

cat gold

ANyone try sta-lube Extreme pressure red grease?? What the specs on the other grease's??

Here are the Cat Desert gold specs


Here are the Chevron Delo EP II specs

Here are the Lubrication Engineering specs

This is the Lucas Red N Tacky that I use.

http://www.lucasoil.com/products/display_p...=2&loc=show

It cost $5 at Autozone.

Socaldmax,
Which one of the LE products do you use? They have two that look good and why not mix maybe!!!! LE's 1250-1253 High Temp or 3750-3752 High Temp Extreme Pressure, both look very good, just need your feedback, thanks.

Straight Bel Ray.