Thought I would share a actuator lightbar I just had made in mesa,az at 2xmotorsports. Looking forward to trying it out in the dunes.











All the way back.




All the way forward.

That looks great. Can you show a pic under the roof to show the actuator?

The actuator mostly sets at or above the 1.75" center bar but at the lowest point the tip of the actuator hangs 3/8" below.

Do you have the specs on the actuator?

It's a firgelliauto actuator.

What's the stroke?

It's a 6" stroke but for this arm 4" is all that's required. I checked firgelli for a 200lb 4" stroke but didn't find one. They may have it though.

I have extra arms also if someone was looking for this same design. Not trying to advertise but I listed these on Ebay to get rid of the extras.