Is there a "brake disc hub" from another Honda that will fit the 70 axle for a rear disc brake mod?

Or do I need to fab one from a stock brake drum?

I converted my 85' to a rear disk and had to fab a hub using the factory drum brake. I never found anything with the same splines that I could just install and ride.... Hope that helps!

Could you provide a little more info/pics on this conversion. What brand/type of brake disc and caliper you used. I have a friend who could some machining to fit as needed.

Thanks

X2 on some pics! I kinda figured that would be the case, using the hub from a stock drum.

I've seen pics either on here or another 3-wheeler site, but I didn't save them.

some shots of how ron does his here starts out as a stock atc 70 drum..

http://www.glamisdunes.com/invision/index....mp;hl=brake+job

this might help for the pics!!

ok here is the skinny.. i took the stock brake drum, cut it off the hub,, cleaned up the hub and slid it right into a 85-86 atc250r brake hub, and welded it in,, took a whole hour to complete,, as you can see in the picture i made the disc hub,, the axle sleeve ,,and the wheel hub,, all one piece,,, just for fun,,

Mike..you can make me one while you are making yourself one as well!

Kasey is the man! Nice brake setup

There are a few posts here about how i did it on my suspension trike and here is the bolt on mod i did on a 73 model.

Nice conversion!
I'm going to have to get one together on my 70, the squeaking and constant need for adjustment is driving me mad. Is that a pit bike conversion kit? I was going to get one but they only work from the foot brake and I want the hand lever or both.