I have a question....what have you done to your wheel wells to get the buggy between them....my last trailer had drive on wheel ramps and bay windows at one side...not an issue...now looking at smaller trailer so it can fit in my drive way....need to back the car in...most measurements are about 77 inches between the wells....and I need 80 inches.....show any pics you have....the trailers I am looking at are some wide bodies and some of the older ones where it might be an issue with the beds on the sides...thanks.

That measurement with trailer skinnies on there?

Just remove a trailing arm each time you need to trailer it.

I have a CR model, i did a spring over, and after the lift ther was room to remove the fender wells and just run flat boards with carpet over them, on the outside they board went equal to the bottom of the fiberglass fender well.

If you need pics pm me