I had a broken spring replaced on my 40' Cyclone to wards the beginning of the year. So last week I decided to double check everything, just to make sure no issues were arising, as I just gotten back from outlet center. I notice that the spring I had replaced was a little flatter than the others (not as much arch). So after verifying the part number on the spring with mfg, it's a 2500 lb and not a 2600 lb. Is this that big of a deal or not? should I replace it? It's on the closest axle (out of 3) to the truck, if that makes any difference.

Thanks

im no expert, but i wouldnt worry about it. really whats 100lbs out of 15,000

I wouldn't think it's that bad either. But not sure. Is it bad running a spring that is that flat?

New Spring
Click to view attachment

Old Spring
Click to view attachment