This might not be the best section to post this, but i need some advice about this mesh stuff that i want to put on my quad,

as some of you see i baught some OMF scoops that attach to my stock Z shrouds, i have seen these scoops made by pingry that uses this mesh and the mesh replaces the stock shrouds, here is a pic of the mesh on the pingry shrouds

where could i get some of this mesh, and how would I attach it to my plastic shrouds? but mainly where could i buy some of this stuff?




but i want to cut some of the inside scoops out of the stock shrouds because i read they dont work as good, so i was thinking of putting on some of this mesh so rocks wont hit my radiator but the air will still flow better than thse stupid stock scoops

its hard to explain since some of you dont know what im talking about and some dont have a Z to compare t, but where could i get some of the mesh in the pic? thx

Buy some sheet metal and a couple drill bits. I would think any shop that sells fabrication supplies like tubing, sheet metal, and steel plate would have it. I couldn't name any off the top of my head though.

How about california metal supply?

most metal suppliers should have perforated metal in stock.

IF YOU BOUGHT THE SHEET METAL AND BITS, YOU MIGHT BE ABLE TO ADD A DESIGN.... THAT MIGHT BE A COOL CUSTOM LOOK