My mendi 2d started leaking from the axle seal is this something a DIY can do? If so where can I buy parts? I would like to replace a cv boot it's flinging grease it's just not fitting very tight where can I buy these as well it's for 930 axles. Any help would be great!

The axle flange seal is extremely easy to replace. Simple remove the aluminum side-plate then the snap ring from the flange. Open it up and you'll see what you're up against. Call up Weddle they will sell/ship you the seal and possibly the CV boot also.

If I'm not mistaken Mike 330R has a write-up on this subject in a recent Sand Sports. I'm pretty sure it's the issue before the one that came out a few weeks ago.

But it doesn't look terribly hard to do.

http://www.glamisdunes.com/invision/index....howtopic=180300

Do one side at a time, dont pull both sides out or the diff is a challange to get straight.

Pretty simple to do.

Thanks everyone for the help I ordered the seals from Weddle and they should be here this weekend so I'll tear into it then!

Make sure to check cv bolt length ,you will see if they are to long when you take apart,there will be rub marks .