Does anybody know the torque requirements for a banshee head?

Thanx,

'Bob

My shop manual is at home. I'll check tonight if nobody answers before then. I'll get the sequince (spelling?) also.

Here is your torque specs for the cylinder head.


Torque to 20 FT-LBS.

Do it in 2-3 stages of tightening. There is a sequence pattern to follow. I'm going to try and draw it on here. If you have the stock head still then the numbers should be on the top of the head, which will corrispond to this.


front of bike


5 8
9 10
1 4
7 6
3 2

Sorry I can't get the #'s to stay spaced. When I go to edit; it shows up fine but when I post they jam into each other. I can try by pming you and see if they hold the position I give them.

Thanks for the response. I can figure the sequence just wasn't sure about the torque load.

'Bob