GlamisDunes.com > 250 R Head Assy.

GlamisDunes.com > Quads - OHV's - Two-wheelers > Quads and Three-wheelers

little blue buggy

Jan 15 2005, 05:44 PM

Does the arrow on the top of the piston point toward the carb ?

is there any tricks to putting in the clips on the rod where the piston is

Does the copper head gasket go on w/out any silicone or anything

Thanks

SychoCR

Jan 15 2005, 05:57 PM

the arrow points to the front of the engine, or front wheel.

just use a real small screwdriver and your fingers to put in the clips, they're not that hard.

all gaskets go on with NO SILICONE.

little blue buggy

Jan 15 2005, 06:07 PM

Thanks

BaNsHeE350

Jan 15 2005, 07:00 PM

QUOTE (SychoCR @ Jan 15 2005, 06:57 PM)

the arrow points to the front of the engine, or front wheel.

just use a real small screwdriver and your fingers to put in the clips, they're not that hard.

all gaskets go on with NO SILICONE.

correct...gotta love 2 strokes, easy to work on

little blue buggy

Jan 17 2005, 06:10 AM

got her back together........runs good

thanks for the help

MrBudweiser

Jan 17 2005, 11:32 AM

QUOTE (SychoCR @ Jan 15 2005, 05:57 PM)

the arrow points to the front of the engine, or front wheel.

just use a real small screwdriver and your fingers to put in the clips, they're not that hard.

all gaskets go on with NO SILICONE.

I always put a little silicone on the base gasket for that added protection. Never had a leak. But it is not necessary but I have been there done that with the leaks. Head and intake no silicone. Put a crap load on the exhaust to get it to seal good, just be carful not to get any on the inside.

This is a "lo-fi" version of our main content. To view the full version with more information, formatting and images, please click here.