I have a 96 banshee with trinity stage 2 porting and stage 4 head, pro circuit pipes, reed spacers and boyesen reeds.I just got the clamp on K&N's with Outerwears and im wondering where to start with jetting. thanks alot.

CALL TRINITY ,THEY HAVE IT ALL IN THERE COMPUTER THEY WILL TELL YOU NEEDEL SIZE PILOT JET SIZE AND A GOOD IDEA ON THE MAIN THEY WILL ALSO SEND YOU A JETTING INSTRUCTIONS PAPER FALLOW THERE ADVICE AND YOU SHOULD BE GOOD TO GO . THATS HOW I DID MINE .

START WITH THE STOCK NEEDLE WITH THE CLIP IN THE CENTER GO TO A 30 ON THE PILOT JET AND START WITH A 290 MAIN DO ATHROTTLE CHOP AND CHECK YOUR PLUGS AND GO FROM THERE.

might need slighty fatter jets than 290's with clamp ons....I'd try a 300 and go from there....My guess up from there...

I HAVE K&N'S AND I USED TO RUN A 290 WITH MY BIKE, BUT HAVE SINCE CHANGED PIPES AGAIN AND NEEDED TO GO TO EVEN BIGGER CARBS

You need to start at least a 320 and go from there. With porting and whatnot... i would give Trinity a call though...

RoostKing...

Definitely start with at least a 320 and test it from there.