J Alper's latest activity
-
I still have not forgotten that day, I work in a factory and we all left the line and ran to the breakroom as everything unfolded, may... -
J Alper replied to the thread New clutch break in.These are not fragile clutches built for the street with ceramics in them, you have a fiber clutch with copper, same as a top fuel...
-
J Alper reacted to EastMT's post in the thread It's Saturday Sept 6th 2025.. What is everyone doing this weekend? with
Like.
Bleeding brakes and clutch on sandcar. Bought a power bleeder and don’t think I could go back to manual bleeding on the sandcar again... -
J Alper replied to the thread Tatum billet spindles / uprights.That is a lot of spindle for the money,
-
For a new build and minor cost increase, I would say yes. In my case, a retro fit, I would have had to REALLY cut my car up to get it to...
-
J Alper replied to the thread Sandblast DVD - Clutch Films.I think i have one, I have a bunch of DVD, is it hard to turn them in to Digi
-
J Alper replied to the thread S5D vs Fortin FRS5.Correct, Lincster thank you for the support. I wish the S4D had a bigger Diff than the S4, only having just the ring and pinion bigger...
-
J Alper replied to the thread S5D vs Fortin FRS5.Will snap a picture have both trans in the shop the Ring and pinion area is much taller on the S4D, than the S4, the gear stack area is...
-
J Alper replied to the thread S5D vs Fortin FRS5.The other part to consider, just going from a S4 to a S4D the trans is much bigger in height I had to move the trans/CV area up...
-
J Alper replied to the thread H pattern dog box.The issue is that the dogs can round the edges, when this happens, it does not hold a gear, I have missed a shift (grind it till you...
-
J Alper reacted to onanysunday's post in the thread Country Coach intrigue 32 ft (((((Solar install))))) with Like.
I really like how this guy mounted his panels on the roof using strut channel. A little more work and adds a little more weight but I...
-
J Alper replied to the thread Trick to removing bearings?.This is the VW Style setup, Really sketchy setup, I like to bore out the hole and weld on the Cheaper Empi Mico Stub kit, then you...
-
J Alper replied to the thread S4 first gen indictor?.For anyone doing this, From the PM's i got, you need to start from the basics, Get this working with a Hand Held Volt Meter before...
