wrightjarred14's latest activity
-
Been running this set up for 4 years. LS7 lifters. Dual Rate Springs. I didnt just throw a 600 lift cam into an otherwise stock... -
wrightjarred14 replied to the thread LS1 Cam Spec.What cam motion off the shelf cam would you recommend? I’m just a duner. I don’t go down the drags, I play in the big bowls behind olds...
-
That cam is pretty much a stock ls6 with a tighter LSA, I think that cam is leaving a lot on the table for a sand car, but would be...
-
That is a Huge cam for a stock LS6 for bottom end ^^^ One issue you will have with a stock cam is Lift, .600 lift on a over rev with...
-
I had the same setup... my LS6 with 243 heads had the Howards Cams American Muscle 197245-12. It had awesome low-end torque. If I...
-
I run summit's 8708 Cam in my LS1/6
-
Apples and Oranges. No cam you install will behave like a supercharged motor. Been there, done that. Cam'd my LS1 etc. Then started with...
-
wrightjarred14 replied to the thread LS1 Cam Spec.No, I’m use to driving my fathers supercharged ls1 car so maybe that’s why I’m expecting more low end torque at that range. Just trying...
-
wrightjarred14 replied to the thread LS1 Cam Spec.It’s a LS6 block so I’d imagine an LS6 cam. It’s a turnkey engine supply motor.
-
wrightjarred14 replied to the thread LS1 Cam Spec.243 Heads I’d say around 1800-2200 rpm
-
what heads, what rpm do you want the cam to start to come in, I would not put a off the shelf street cam in a desert car with low gears,
-
What’s the best off the shelf cam for an LS1 Sandcar? Looking for more low end torque. I’ve talked to a handful of people and people are...
-
Merry CHRISTmas to all
-
Wanted to wish all y'all a Merry Christmas. Our families have always come together on Christmas eve to celebrate this holiday. Tonight...
-
wrightjarred14 replied to the thread 2006 Amplified Performance.Yeah, I’m in Phoenix. I know there’s a handful of guys out here too
