Search results

Ready to rock and roll!!!!

Alex and Steve got everything straightened out and finished Dyno up last night. 11.5 lbs of boost, plenty of timing, AFR were controlling within 1-2%.  I am very happy with the numbers. Worked with Drew at Grip Tech and told him my target boost.   He suggested a 1:1 on the rear of the blower...

Holy crap!!!!!!!  Sorry about that!!!!!

Haven't posted in a while with updates. Wiring is done, bypass are on, camber/caster are set. Had an initial dyno run last week. Car ran strong then developed some weird rich/lean issue.  AFR's were all over the place, couldn't get a torque curve on the laptop then fuel pump died.  So that...

Installing them in my car as I type.  very excited to be done with relays.   

Ready to go to Alex tomorrow for wiring.

King Springs 2 - 14” 450 lbs. 3”. Fits a 2.5” coil over.   2 - 16” 600 lbs. 3”. Fits a 2.5” coil over.    $40 each.  You pay shipping.  East Mesa AZ.  Call or text.  480-231-6386

I upgraded to the Trax system so selling my old system.  Works fine.  4 person set up.  Intercom, ICOM CB for car to car.  Antenna.  All wires and cables that the system came with.  Bought new in 2009.  No pix as my garage is a mess.  $800 obo.  You pay shipping. East Mesa in AZ.   

Little hard to see with my back bar on. 

Couple updates.  Battery will go on floor space that is empty along with Holley computer and MSD solid state relay. 

Couple more from the weekend. Motor is 100% done, just finishing up a few AN lines. I will get more pix tonight. Car will be ready to go back to Alex by end of the week for wiring.

Coming along!!!! Motor and trans go in tomorrow.  Then gotta make lines and it is ready for wire.   

Got everything back from Powdercoat. Floor is recoated. Chrome/Polish should be done Friday. Let the fun begin!!!!

I went to 2" hollows so getting rid of my old stuff. Spindles were made by Denny Foddrill. There are 3 because I had my old spindles for back up. I broke 1 of my new ones, so I used my old one to finish the season. The upper threads on 1 of the driver side are messed up, but can be fixed. 1...

Alex will finish up this week. Just need to finish welding up seat brackets, put motor/trans back in. Remake my floor for the back section. Check axle length to verify axles aren't too long. Just a few things. But here are some pix of finished trans mount areas, shifter console.

Getting rid of 2 Heat Exchangers/Oil Cooler. The bigger one is a custom made exchanger that CBR added a fan shroud and fans. Spall 8" fans, pullers. Dimensions are in the pix.  Selling this one for $275. Smaller one is CBR Part Number 2827.  It is classified as an oil cooler, I used it with...

Few more updates. Not a great pix, but console is done.  Will hold radio and shift indicator. Fuel tank modified to hold an extra 7 gallons.  I was always first to run out of gas.  LOL Intake is being mocked up now.  Will be a dual intake like my last one. Alex had to have an O ring groove...