Search results

I have my Bookmarks to open the site to View New Post, and normally it would show all of the newest posts.  Now it is showing this:

Does anyone actually bother with getting this for glamis?  Do they actually enforce it?

The road is paved now.

I think these would look great, finishing off the current look.  What do you think?

That is what I used with a 100A fuse.  It looks like one side might of loosened up and overheated causing the fuse and holder to fail. After looking up the holder I used it appears to have a nylock nut on it so I doubt that it loosened up. 

What is everyone using to protect the charge wire from the Alt. to the Starter?  Fuse, Fusible link?  What size wire, and Alt. Rating? Thanks in advance.

Siroflex New Style Deluxe Double Swivel Sprayer,Chrome & White,One Size I have this, and it works great for the trailer kitchen faucet.

Does anyone know what time the Aragon MotoGp race is on tomorrow?  According to the list CNBC is supposed to be showing it 1:30 ET, so 10:30 Pacific, but the guide doesn't list it at all. 

@John@Outfront John, is there a different bracket that supports the alt. when not using a power steering pump?

You mean Austin Forkner.  She is Rylee Kirk

303 Aerospace Protectant got greedy and wanted $60.00 for a gallon, so switched to: VRP $37.44 for a gallon, and I dillute it with distilled water in a spray bottle like suggested by a user that is a Pro. Detailer.

LTS is Rebranded Hikvision and they write their own Firmware for Cameras and NVRs.  (Same brand I use) I have installed a couple of these. Platinum Enterprise Level 64 Channel NVR 2U LTN8964-R  Ran more than 10,000' of Cat 5, and installed 58 4MP cameras for the most recent one.

Happy B-Day!!!!! 

Using the needle again I pack the CV in the hub with Swepco and put a layer of BelRay on top of that. All bolted up. I get the boots on and tighten them down and the CV's and axles are done.

@L.R.S. This was posted by LRS Pre Crash.  It had a much better format, and I am sure that I am missing a few things (I abbreviate to save page space) Same here but I use Swepco Moly 101 to pack the CV's and then a layer of BelRay Anti Seize over that on each side of the CV. I also fill the...

To troubleshoot the fan being constantly on, if the ecm is powered up, and no signal to E. Temp pin (this will eliminate the possibility of the engine temp sensor being bad) then under normal operation there should be no continuity between Fan Pin and Sig Gnd correct John? Or 0 volts reading...

Do you have any contact cleaner?  Can you clean the 9 solder joints thoroughly to see if there are any voids similar to what I posted?

This is from a Link ECM, note the circled pins.  This car was @John@Outfront Shop a couple of weeks ago, and had very similar symptoms.

I ordered this one.Oil Pressure Sending Unit - Subaru (25240KA041)