Search results

Had same issue at old house. Sink was a 1-1/2" line at far side of house. it took 75' snake to reach far enough to meet main line on other side. Had a disposal but the small line made for occasional clogs(spaghetti, rice etc..). Point is, maybe your not reaching far enough downstream to clear...

33"x15", 1 cut Blasters and 8.50x15" Razor Fronts. Going to 32"x15" Tusk Sand Lites. Lighter, bigger and more buoyancy. The ruts and chatter bumps are killing me with the Razors. Even at 5psi.

So if I have a 2" coilover with 200lb bottom and 150lb top, both 10" springs. Would you still want the same spring rate. ie...250lb-14" spring on bottom and a 100lb-6" spring on top. Or does everything change spring rate wise? And what is meant by "low speed holes drilled out"?

now that we all agree that they are terrible. Has anybody tried those fatter SxS tires, instead of the 3 ribbed razors and if combo hubs can handle them?

I have an Extreme Fabrication, 2 seat, mid engine V8. No bypasses(Piggyback 2.5's) and is a super light car. The ruts and cross tracks a killing me. Its getting to the point that I don't look forward to the next ride. I've lowered the front air pressure down to 5psi with some improvement. The...

Looking for a used set of above front tires.

Used one last season on front of a 4 seat, SU car for about a mile. Wore a 3" hole in in bottom. Last heard they would be replacing it under warranty.

Seagram's and Ginger Ale

Check insurance rates first. Mine tripled when I registered it in AZ from Cali....

She done! My buddy and I used a 17mm Bolt extractor, Map gas, 2' breaker bar, and a 2" pipe extension.  I heated the bolt, hammered on the extractor and pressed my foot against it as my buddy slowly herced the bar and tube. With a scary amount of force, it gave way. Weren't sure if we rounded...

I learned getting flywheel bolts out when someone used Red loctite in is next to impossible.

Have a 2 seat, mid engine car. Had new trailing arms made before last season(7 trips). I've noticed a clanking sound which seems to be coming from the pass side trailing arm, Upon inspection, I noticed that there is space between the busing and tabs on both sides of the bushings between the...

Looking for a guy in the East Valley area. Need an upper pan resealed on my 2016 6.7L

Cleaned roof good. Eterna bond over/around existing caulk of everything attached to roof. Dicor self leveling over edges of Eterna bond. Then 2 coats of  Henry's white Tropicool roof sealant. First pic is during prep, second is after 1 coat. Forgot to take another after second coat.  5 years...

At peace...........