S4 first gen indictor?

[Goatpoker]

I'm adding a gear indicator switch to my gen1 S4. I'd like to use it with my Holley Dash, has anyone done this and willing to share the details?

 

[Grease Monkey]

I will be doing the same on mine soon. This is how I am going to do it on the Holley system.

0-5 volts in/out so should be similar as this video.

 

[Goatpoker]

Thx GM

 

[Grease Monkey]

Thx GM

When are you going to do this?
Will you let me know how it goes.

 

[J Alper]

I have set up about 5 of them,

Pretty easy with the Holley,

just set it up like the Alternator readout, readout is volts,

S0 setting up a volt meter,

On the Side you can read what is on the dash, for example you will have 1 2 3 4, volts for ready out
and on the bottom scale, you will put .75-1.25 equal 1, and 1.75-2.10 equals 2

you want to set up a range of volts to read the output number on the dash, that way you do not have the number on the dash move around,

I start with checking the voltage on the sensor at the transaxle,
But all and all you are just setting up a volt meter,

 

[J Alper]

I will be doing the same on mine soon. This is how I am going to do it on the Holley system.

0-5 volts in/out so should be similar as this video.

This is a really hard way to set up a Stick shift, good for a automatic, but i would do a volt meter process,

will send a pick of the setup, take only a couple of minutes to setup the volt meter process