Recent content by Kick310

I started with a J&J aluminum car. Every other trip I had to weld the car up. Car was a blast but definitely not the safest car to ride in.

I get this one at the Carniceria. Amazon has it but it’s almost twice as the store. 

I made some from spare tires. Flush to the outside lugs. 

Pismo Beach with the family. 

I have used these before in a pinch. Only $5.00 for a 24 pack at HF. 

Almost tripled from last month. 

Your settings on the panel should look similar to this. If you are using shielding gas the settings are different than flux core. Also a mistake that I’ve done is forgetting to put the ground clamp on the work piece.   

If you open the side lid it should give you some baseline settings for the wire speed and temp. I usually weld a little hotter than the recommended setting. Also make sure to clean the are that your going to weld on by getting the mile scale off. 

$5.25 in Carson. 

1 1/2 inch chromoly. Prerunner. 

Helping out a friend in Glamis. 

This was right on Gecko Road in front of the store.  Prius versus a Can Am