2005 Alumi Craft Dash - Owner / Mounting Info?

[wesinls]

Anyone know who owns this car? I have the same dash that I plan to put on a rebuild, and am curious how the steering shaft is mounted to the frame. Hoping the owner has a pic of the frame without the dash on.

 

[Sandkist]

Pretty sure all Alumicrafts of that era used a tube welded to the cross bar with oil lite bushings pressed in from each end.

 

[acefuture]

I believe its one of these. But that does look a tad lower. Ill ask Sky to snag a photo of his

Laser Innovations 03-111 Weld-On 3/4" Steering Shaft Support Bracket With Bronze Bushings - Kartek Off-Road

Laser Innovations 03-111 Weld-On 3/4" Steering Shaft Support Bracket With Bronze Bushings for offroad racing in the King of the Hammers, New Zealand Taupo 1000, Dakar Rally, Tatts Finke Desert Race, Score International Baja 500 or Baja 1000, Mint 400, Vegas to Reno, Silk Way Rally, Crandon...

www.kartek.com

 

[wesinls]

ya, it looks to be lower than what I've seen on other cars. Here's pic on the project car...im trying to get info to help the fab guys as this was one of the items we were not sure how it is going to be done. Balance of looking good, angle of dash, but at the same time not too low / too close to the knees.

 

[acefuture]

Here’s Skys. Flat plate welded to the cross tube