Old Funco Gen 4 934 mid board hubs

[AlpineFunco]

I picked up some 934 hubs. They were disassembled, cleaned, and put into a box. I've got a question about assembly. Can someone confirm that the spacer goes on top of the rotor hat as pictured in pic # 2 and NOT between the bearing and the hat as in Pic # 1. And also, the flange in pic # 3 is used on the trans side cv's, correct? And does anybody have a part number for the seal that I need for this?

Thanks

 

[ROBERT L]

sounds like a question for @parker@gearone

 

[John@Outfront]

turn pic number 1 over and take a pic there needs to be a special flange there with threaded holes
i dont see your six long bolts to assemble
the main seals are timken 417556 and will be at least $100 each
the inner lip seal you might not know you need is VL170
turn the hat over and take a pic of the inside
yes the flat steel spacer goes on the outside of the aluminum hat

 

[AlpineFunco]

turn pic number 1 over and take a pic there needs to be a special flange there with threaded holes
i dont see your six long bolts to assemble
the main seals are timken 417556 and will be at least $100 each
the inner lip seal you might not know you need is VL170
turn the hat over and take a pic of the inside
yes the flat steel spacer goes on the outside of the aluminum hat

I have the bolts, just used two to hold it together.

 

[John@Outfront]

looks good

 

[AlpineFunco]

looks good

Thanks John. The flange in pic 3 of my original post is for the trans side cvs, correct?

 

[John@Outfront]

Thanks John. The flange in pic 3 of my original post is for the trans side cvs, correct?

Correct

 

[AlpineFunco]

Thanks!!