Sandcar / Off-Road Parts
420 topics in this forum
-
- 5 replies
- 347 views
Funco dash with Livorsi gauges and gps. North Fontana 80 bucks. Pickup only. 909-229-one eight 74
Last reply by ChasingSand, -
- 3 replies
- 868 views
Dune Sport 14.5-15 #2 paddle Shaved Baja Pro 33” Beauty rings $2600.00 obo Tires are in Great shape no chunks or plugs 951-520-3002
Last reply by RPMsRUP, -
- 7 replies
- 2.3k views
From my Gen 4. Bearings and races still good and serviceable. Includes new set of brake pads and new CR seals. I switched over to a micro stub setup. I believe these were gray area hubs? I also have a box of 930 CVs somewhere and can probably put together a set of 4. One of the 6 bolt CV boot retainers is damaged and can be massaged and repaired or replaced. What is it worth??
Last reply by danwalker, -
- 1 reply
- 807 views
I bought this to modify and fit my car, going in a different direction, I paid $300 for it would like that out of it $300 obo Jonathan 951-520-3002
Last reply by RPMsRUP, -
- 1 reply
- 477 views
Funco Gen 4 rear trailing arms and 930 midboard hubs, comes with brakes and axles and CVs all complete. come with bag mounts and bags, going to larger setup $2000 OBO
Last reply by RPMsRUP, -
- 1 reply
- 920 views
Funco Gen 4 Trailing Arms and complete 930 midboard hubs and brakes, comes with axles and inner Cvs, NO BAGS OR BAG MOUNTS, $2800 OBO Jonathan 951-520-3002
Last reply by RPMsRUP, -
- 0 replies
- 338 views
Funco GEN4 930 trailing arms hubs axles cvs brakes $1000 located in PHX Ben 6o2 91o 2o14
Last reply by SANDBAM, -
- 0 replies
- 358 views
Set of Funco gen 4 trailing arms for there 930 mid board hubs $500 located in Anaheim call or text 714-240-2116
Last reply by Householder, -
- 1 follower
- 2 replies
- 1.9k views
Used dash pod and gauges with harness. As removed from my Hustler. Make an offer. Senders still in the engine.
Last reply by Grease Monkey, -
- 1 follower
- 1 reply
- 2.1k views
Good used set of shocks with bypass tubes. Bags have cracking but hold air. Was told to run em as is and did. Anodizing has a blue tint to it. Not sure if it's faded black or they were done in a dark blue. See photos. No history on any previous service. No oil leaks. Updating the car so these are for sale. Rear bypass shafts measure a tad over 15inches. I believe these are sold as 14 inch bypass shocks. Prefer to sell as a complete set. $2500.00 obo.
Last reply by Grease Monkey, -
- 1 reply
- 466 views
GEN6 Funco OEM parts for sale Roofline Bar set $1500 dash $500 hood sides $500 nose cap $450 side scoops $250 GEN6 dual fuel tank set $1650
Last reply by SANDBAM, -
- 2 replies
- 762 views
Inner cooler set up for funco project Edlebrock intake fits ls3 Throttle body has TPS and IAC new Spal fans never run located in PHX $2500 BEN 602-910-2014
Last reply by SANDBAM, -
- 1 reply
- 1.9k views
Sold Sold SOLD Alper Sequential Shifter *** Brand New!! Never mounted or even mocked-up SOLD LazerStar 14'' Light Bars, Work Perfect $125 All items located in Redlands Ca. 92374 (So Cal) Thanks for shopping! 🤑 Paypal Accepted & willing to ship all items . Tim 9o9-233-9o51 (text preferred please)
Last reply by PICKUPYOURTRASH, -
- 2 replies
- 1.3k views
Funco Dash W / Gauges & Garmim GPS & Box of Wiring $SOLD$ K&N Filter off LS $40 LazerStar 14" Light Bars $60 Chevy LS McLeod RXT Double Disk Clutch & Flywheel, 100% complete & working perfectly. $550 Funco LS7 hard radiator lines. $40 All items located in Redlands Ca. 92374 TEXT Only Please 9o95576o68
Last reply by PICKUPYOURTRASH, -
- 1 follower
- 8 replies
- 1.1k views
I bought these a few years ago as spares for my buggy. they had the aluminum CV Flanges & the flanges were beat up pretty good. I called @parker@gearone @Gear One and he set me up with a new set (they had them sitting on the shelf). I have not done anything to these, I have not even cleaned the grease off of them, just bought the flanges & stuck them in the trailer with the rest of the spares. The bearings & seals are used. some of them are OK, some are junk. the 3 CV's are used out of my buggy. I found one tore up during summer maintenance so I switched all 4 of them to @J Alper CV's in the buggy. They are great for spares. There are …
Last reply by Bobalos, -
- 0 replies
- 472 views
Full set of front and rear Gear One buggy hubs. Includes rear super greasers with 934 33 spline cvs, 12” vented rotors, and (1) 6 piston gear one caliper with pads. Front is 2” hollows (snouts included) with 11” rotors, 4 piston calipers with pads. All bearings and races are good in the front and rear hubs, you will need new seals for the rears. Will also need (1) 6 piston rear caliper ($600) from gear one to complete the set. Wide 5 buggy pattern hubs (5x205). Feel free to message me any questions or for more pictures. $5500 for everything. Located in Riverside Ca
Last reply by Cjs951, -
- 0 replies
- 569 views
Posting for a friend. Gear one mid board 930 hubs. Upgrading to 934...
Last reply by Looney Duner, -
- 3 replies
- 274 views
I have 3 complete GearOne 934 CVs with 300m cage. They are in good used condition and show normal wear. $125 each plus shipping. Also have 1 GearOne 934 CV with 300m cage but is missing the star and one ball. $75 plug shipping. Located in Phoenix. Thanks!
Last reply by parker@gearone, -
- 2 replies
- 1.1k views
Going a very different direction with this car and this new sheet metal isn’t going to work. I’m looking to get $2500 for it. Hood, side panels, windshield, dash, roof & wing trunk. The side panels, dash, roof & windshield are all wrapped. Alex 714-420-4331
Last reply by Pennywise, -
- 2 replies
- 1.4k views
Got Ls headers used two times.. decided to go twin turbo.. 450.00 951-7571752 leave message
Last reply by GeneralG, -
*No longer available Took this out of a Gen 3 hustler located in Anaheim $ Free Alex 714-420-4331
Last reply by BigRay800, -
- 0 replies
- 712 views
Used wheel off my Funco. 25 bucks. Costa Mesa CA Or ship on your dime. Thanks.
Last reply by Grease Monkey, -
- 1 reply
- 235 views
Brand new Hargett Dual Lever Mendeola Sequential Transmission Shifter For S4, S4D, S5, S5D. located in OC $600
Last reply by HBLOWEN, -
- 1 reply
- 915 views
I just removed these from my car they work great. I went with HID. 2 lights with ballasts. 100 bucks located in North County SD
Last reply by SANDFORME, -
- 5 replies
- 1.9k views
Ordered for a build, but was damaged during shipping. Holley doesn’t want it back. Little time with a file and it’ll probably be fine. $150
Last reply by Rockwood,