Funco Motorsports
83 topics in this forum
-
Funco Family 1 2
by SandTrap- 2 followers
- 41 replies
- 8.7k views
I am Very Honored and Humbled to one of the VERY many many People that are part of the Funco Family. Lets see your Funco's and your story..
Last reply by tjZ06, -
- 1 reply
- 1.4k views
Pretty sure I documented this on the old site but I had to replace a Gen 4 rear air bag and found this SKU W01-358-6902. Anybody know a SKU for the front airbag for a gen 4 2.5 shock?
Last reply by Grease Monkey, -
- 2 followers
- 17 replies
- 3.6k views
Ok, I’ve had a Gen 3 all these years. Just got a Gen 4 and it’s time to take things apart. Got the trailing arms off, had to use a sawzall as two of the bolts had welded themselves to the bushings. On to the Cv’s. Got them out, soaked in diesel, and wiped down. Not super impressed with how they look, but I may be able to squeeze another season out of them before replacing. The hubs; got most of it apart. Got the CV body out and the bearing that it goes onto it. got the inner piece that it bolts to out and wiped down as well. Pulled the 5 bolts that hold the housing to the trailing arm and thought maybe it’d just pop out like everything …
Last reply by AlpineFunco, -
- 1 follower
- 34 replies
- 6.7k views
The stock uniballs for the rear suspension are exposed and go away quickly if you put a lot of miles on your car. This was maybe 3 seasons. Outfront John sells a set of 8 seals that pop in there. I put a little grease in there and it appears it should work just like a wheel bearing seal. With much less movement. I believe they will last MUCH longer without getting exposed.
Last reply by Bobalos, -
- 4 followers
- 23 replies
- 4.9k views
I have never done a build thread and since everything got wiped out I thought I would do one on our current project. I picked up this car as a spare last season and the project started almost immediately and has been ongoing. Car started out as a 4 seat Gen 4 with 934’s, S5S and a Danzio Brutus motor. In my infinite wisdom I decided to put a 4.5 liter whipple on my 11:1 stroker motor and put the boost at 14 psi on E85. I took it to Turnkey and then Funco to cram the whipple in the car. Grant told me it was a bad idea but if we are going to do it let’s do it right. So we took the back seats out and put the big tank and the gen 6 radiator in the car. He then said …
Last reply by DZRTRUN, -
- 0 replies
- 609 views
Hi GD.com, Who has recent personal experience with having chrome work done? Looking for recommendations for my Gen4 suspension parts. Any good SoCal shops? Or is it best to go out of state? If so- who do you recommend? TIA!
Last reply by K73, -
- 3 replies
- 1.6k views
Can someone get me some measurements off there Gen 6 car? Need A, B, and C pillar heights from the center bar on the chassis. Front nose bar width. and a pic or two of the rear shock mounts on the chassis. Thanks
Last reply by URCLEVER, -
- 7 replies
- 2.2k views
So happy to be back on line 👀
Last reply by SandTrap,
